Highly effective Bunker Stabilization with Bunkertac
Bunkertac is a special purpose binding agent, specifically formulated for soil and sand stabilization.
Bunkertac is an environmentally friendly and technologically advanced stabilizer and erosion preventative which is highly effective on golf courses for:
The key to the exceptional performance of Bunkertac is its ability to cross bond and solidify the soil or sand particles.
When used for bunkers, Bunkertac will meet the requirements of a flexible bound surface with a high load bearing and shear strength capacity while allowing for drainage, prevent distortion and disfiguration of the bunkers shape, prevent contamination of the sand contained in the bunker and most importantly reduce initial application, repair and maintenance costs.
When used for sand flashing, Bunkertac will actually hold the sand in place all throughout the bunker most specifically on the face and along the edges thus improving the aesthetics and ensuring that the original intended design of the bunker has been met.
Benefits of using Bunkertac for stabilization of Bunkers include:
Bunkertac FAQ
Bunkertac is completely environmentally friendly, safe for animals, wildlife and vegetation and dries clear and transparent; leaving the environment in its natural state. Bunkertac meets all ISO 14001 requirements thus helping to keep all companies involved compliant.
Bunkertac is a cost effective solution since it is less expensive, easier to install, easier to repair, requires less maintenance and out performs any competitive product on the market.
Bunkertac will not harm the grass surrounding the bunker it will actually enhance the grass growth around the bunker. Over spray will actually help prevent further contamination.
Future maintenance will be significantly reduced as the Bunkertac application will prevent or reduce contamination, washing and erosion of the sand while improving drainage and holding the sand in place on the face; thus eliminating the need for constant raking and pushing of the sand back into place.
The Bunkertac application will last a minimum of 3-4 years if applied according to On-Course Solution’s Bunker Stabilization & Sand Flashing Instructions and the After Treatment & Maintenance Instructions are followed.
The Bunkertac application followed by the placement of the USGA recommended amount of sand will reduce the chances of a “ball-lie” or “fried egg” and improve the shot value; thus enhancing the playability of the bunker.
The Bunkertac application process including our specialized method for the sand flashing is purposely designed to ensure the sand is held in place on the steepest of faces and edges.
If possible it is best to compact the bunker 3-4 days prior to application of the Bunkertac to give the soil a chance to relax before application.
The ideal soil condition for the best results is at the Optimum Moisture Content. Pre-wetting of the soil reduces surface tension and helps to assure uniform coverage and maximum penetration
A 1 inch or 25mm diameter hose is the best size hose to use for the application of Bunkertac in order to ensure proper flow rates and to meet the specified application rate.
The recommended application rate is 0.70 litres per square meter
The proper ratio is 1 part Bunkertac to 8 parts water (this may be increased to 9 parts water if the soil requires)
Always fill the container with the required amount of water then add the Bunkertac to the water
To ensure that the specified application rate is met 6 coats of Bunkertac are required
Each coat of Bunkertac must be given sufficient time to penetrate and become tacky before application of the next coat in order to avoid developing an under performing skin layer rather than the desired penetrating layer. This can be anywhere between 1 and 24 hours depending on conditions.
After Bunkertac application the bunker must remain free of watering and traffic for a minimum of 24 hours. During winter months this must be increased to 48 to 72 hours.
Sand should be dusted simultaneously or immediately following each coat of Bunkertac then the USGA recommended amount of sand placed in the bunker.
The best method for dusting of the sand is to use a knapsack type duster blower.
(Contact On-Course Solutions for the recommended machine)
BUNKER STABILIZATION BROCHURES
Bunkertac Brochure
Bunkertac Product Overview
Get A Quote for your Perfect Bunker Project Today
On-Course provides site assessments, and on site training to your current construction and maintenance teams. Let us know what your requirements are?